- It is FORBIDDEN to light the stove before the minimum amount of water is filled in the tub, as this can cause the stove to overheat and deform!
- Before lighting the stove, always fill the tub with water at least 5 cm above the upper water connection pipe to the stove. Once you are sure of the required water level in the tub, start lighting the stove.
- For tubs equipped with a massage system, the maximum allowable water amount is 5 cm from the top edge of the tub when the maximum number of people is inside. Note that excess water will flow over the edges and may cause flooding of the massage pump and/or electrical connections.
- Use dry firewood as fuel! Do not heat the tub with coal, briquettes, or anything else that seems combustible at the time.
- Periodically, as needed, check the condition of the chimney and clean it. Also, empty the ash box in the stove.
- ATTENTION! Do not empty the tub of water until the stove is completely extinguished. If there is still even a small flame in the stove, leave the water.